This project is to get humidity and temperature readings from DHT-11 and show the values on 4-digit seven segment display.
Microcontroller pin connections are:
PORTA Pin_0 for TM1637_CLK (Display)
PORTA Pin_1 for TM1637_DIO (Display)
PORTA Pin_2 for DHT11_1Wire (Sensor)
and of course VCC and GND for every module.
You can get the code here.
I made MAX7219 for C51 but now I need it for STM32F103 too. The wiring is simple: MAX7219_CLK hooked up to PORTA0, MAX7219_...
The picture below is a P10 LED module. A module contains 16x32 single color LEDs, could be red, yellow, green, blue, white or purple. The co...
Simply a 0-24 mA signal generator using AT89C2051/4051, PCD8544 monochrome LCD (was used for N5110 phone), DAC7611 (12-bit 1-ch DAC), TL494...